Battery

Using a GEL battery that was intended for the office power supply.

The plan is to not discharge this battery below 50%, effectively extending it's lifespan.

The battery an charger is inside, on the floor of the cabinet.

Charger

12V 6A (iirc) Gel charger.

The charger is directly connected to the battery.

This appears to be the only photo I have of the setup:

• U1: RB2011-Home
• U2: Fibre panel
• U3: PSU V2_0_A (built in a dead TP-Link TL-SG1016D chassis).
• etc...
• On the floor - You can clearly see the "12V/24V Intelligent Pulse Repair Charger" next to the WDCloud and fibre router, and not so clearly behind the charger the battery.

DC Distribution Board

There is no DB board at the home cabinet.

The power supply features a 10A fuse.